Toshiba Magnia 550d - Manual (Page 159)

Installing Software
Windows ® 2000 Server
143
Installing the VIA 4in1 driver
Follow the procedure below to install the VIA 4in1 driver.
1 Start Windows 2000 and log on as an administrator (or a user
with equivalent rights).
2 Insert the Server Setup Tool CD-ROM in the CD-ROM drive.
3 Execute the "Setup.exe" under the directory path "<CD-
ROM>\PUBLIC\UTILS\GIGABYTE\VIA4IN1," using
Explorer.
$ When you use an IDE HDD with this server, simply installing
the VIA 4in1 driver may not enable the Ultra DMA mode. Per-
form the Ultra DMA mode setup after completion of
installation.
1 Start Windows 2000 and log on as an administrator (or a user
with equivalent rights).
2 Open the Windows 2000 "Start" menu, and select "Settings"
and "Control Panel", and double-click "System."
3 Select "Hardware" and "Device Manager."
4 Select Primary and Secondary IDE channels in "IDE ATA/
ATAPI Controller," click "Advanced Settings," and set
"Transfer mode" to "DMA."
Procedure after installation of Windows 2000 Server
After installing Windows 2000, perform the following procedure.
Installing the display driver
After you have installed the VIA 4in1 driver, follow the procedure
below to install the display driver.
1 Start Windows 2000 and log on as an administrator (or a user
with equivalent rights).
2 Insert the Server Setup Tool CD-ROM in the CD-ROM drive.