Toshiba Magnia 550d - Manual (Page 63)

Connecting Hardware Devices
Installing and removing optional devices
46
$ There are several types of screws available. Be sure to use a
screw for the same hole in which it was previously used.
Screw A
(Screw
thread by
inch system)
- For fastening a hard disk drive
to the drive carrier
- For fastening the adapter plate
for the 5.25-inch device bay
and SCSI HDD to each other
- For fastening an expansion
card
Screw B
(Screw
thread by
metric
system)
- For fastening an optional
device (MO, DAT, etc.) other
than the hard disk drive to the
drive carrier or rail.
Screw C
(Screw
thread by
inch system)
Spare screw
- For fastening a hard disk drive
or SCSI device to the 5.25-inch
device bay
- For fastening the drive carrier
to the server
You should try to reuse the origi-
nal screw, use this spare screw
only if the original is lost.
Stud
This stud is not generally used
because it is supplied as a spare
part.
Rail
- To be used for installing a hard
disk drive or SCSI device in
the 5.25-inch device bay.