Toshiba Magnia 550d - Manual (Page 153)

Installing Software
Windows NT ® Server 4.0
137
Installing the VIA 4in1 driver
After you have installed Service Pack4 onwards, follow the
procedure below to install the VIA 4in1 driver.
1 Start Windows NT Server 4.0 and log on as an administrator
(or a user with equivalent rights).
2 Insert the Server Setup Tool CD-ROM in the CD-ROM drive.
3 Execute the "Setup.exe" under the directory path "<CD-
ROM>\PUBLIC\UTILS\GIGABYTE\VIA4IN1," using
Explorer.
$ When you use an IDE HDD with this server, simply install-
ing the VIA 4in1 driver may not enable the Ultra DMA
mode. Perform the Ultra DMA mode setup after comple-
tion of installation.
1. Start Windows NT Server 4.0 and log on as an administrator
(or a user with equivalent rights).
2. Select "Start" - "Program" - "VIADMATOOL" and mark
checkboxes in the "Current Setting" dialog box.
3. Click "Reboot" to restart the server.
$ When you use a SCSI HDD or SCSI RAID with this
server, a SCSI device will be displayed when the VIA 4in1
driver DMA tool utility is activated. The SCSI device is
only displayed, and this does not allow you to display
DMA mode or perform DMA mode setup.
The DMA utility allows you to set up the IDE device trans-
fer mode.
Procedure after installation of Windows NT Server 4.0
After installing Windows NT server 4.0, perform the following
procedure.
Installing the display driver
The display driver that was automatically detected by the
Windows NT Server 4.0 installer is set to VGA mode (resolution
of 640 by 480 dots). If high-resolution must be set, follow the