Lull 6K Service Manual - Manual (Page 431)

Boom and Transfer
Service Manual — Models 644B, 6K, 844C, 8K, 1044C, 10K 6-181
b. Bleed any remaining oil into a suitable container and remove hoses
from inside middle (rear) boom section (Item 3). Tag and cap hoses
and fittings.
39. Flip middle (rear) boom section upside down and place on work
stands.
40. (Ref. Fig. 6-196) Remove hydraulic tubes from bottom of middle (rear)
boom section as follows:
a. Remove two (2) each nuts (Item 7), lockwashers (Item 8), and tube
clamps (Item 9) securing each set of auxiliary and carriage tilt
hydraulic tubes (Items 5 and 6) to bottom of middle (rear) boom
section.
b. Loosen screw on cushion clamps (Item 10). Slide cushion clamps
out of channel and remove hydraulic tubes from boom section.
Fig. 6-197: Side Slide Pads – Outer Boom Section
41. (Ref. Fig. 6-197) Remove side slide pads from outer boom section as
follows:
a. Remove four (4) capscrews (Item 1) and lockwashers (Item 2)
securing side slide pads to outer boom.
b. Remove the two (2) slide pads (Item 4) and shims (Item 3).
J1
2
3
7
# Description
1 Button-Head Socket Capscrew
2 Lockwasher
# Description
3 Shim
4 Side Slide Pad
4
3
1
2