Lull 6K Service Manual - Manual (Page 76)

General Maintenance
3-8 Service Manual — Models 644B, 6K, 844C, 8K, 1044C, 10K
• Avoid spraying water on electrical components such as the alternator,
starter, gauges, and electrical items under the dash.
• Be careful around the fuel fill and hydraulic reservoir breather. Water
may get into tanks and damage fuel and/or hydraulic components.
• To help prevent freezing, allow water to drain or dry before operating in
cold weather.
Cleaning the Cab
• Clean dust and dirt from all areas of the cab. Be careful to keep water
spray away from electrical components under the dash.
• Clean vinyl items with commercial vinyl cleaner. Treat with vinyl pro-
tectant to guard against ultraviolet damage. Do not use vinyl protectant
on rubber or plastic controls if it will leave them slippery.
• Clean the windows inside and out. Remove any decals from windows
that are not original equipment.
• Carefully clean plastic gauge and indicator lenses. Use a soft cloth and
a cleaner suitable for plastic. Dust and dirt can scratch the clear
plastic.
• Make sure step and hand holds are clean.
• Remove accumulated dirt from brake and accelerator pedals.
Cleaning Decals
If soiled with dirt, clean decals with mild soap. Use a mild alcohol solution if
soiled with grease. Do not use solvents that may damage the decal.
Replace all damaged, missing, or painted decals that cannot be read. On
refurbished or replaced parts, all missing decals must be replaced.
See your JLG dealer for replacement decals and placards.
Attaching Decals
The surface on which a decal is to be attached must be dry and free of all
dirt and grease. Remove the backing from the decal and apply decal in its
correct location. Once in place, rub entire surface of the decal with your
thumb, applying sufficient pressure to ensure good adhesion of the decal
to the mounting surface.
Storage
The following procedures are to be used if the machine will not be
operated for a long period of time.