IKA labworldsoft - Manual (Page 101)

- 101 -
,.$ :HUNH 'DWDFRQWURO '$ 
With '$  from the IKA Laboratory Technology company laboratory devices with analog inputs
can be integrated into the ODEZRUOGVRIW control and evaluation system; in the following these
devices are referred to as DQDORJ GHYLFHV for short.
'$  converts the digital control signal that is supplied by ODEZRUOGVRIW via the serial interface
into analog current or voltage signals which are capable of being interpreted by the various
analog devices.
'$  is able to convert practically all of the signals provided by upstream functional blocks into
the corresponding analog current or voltage signals.
2XWSXWV
3RUW  Four switchable output ranges
(optional) 0-1V,
0-10V,
0-20mA and
4-20mA
3RUW  Four switchable output ranges
(optional) 0-1V,
0-10V,
0-20mA and
4-20mA
3RUW  A fixed output range 0-5V
3RUW  A fixed output range 0-5V
A maximum of four analog devices (or four control inputs from one analog device) can be
triggered at the same time via '$  . The input paths or analog ports are capable of being
activated in the parameters window. Assignment of the analog devices to the '$  ports is
performed in a downstream window.
Classification of the analog devices into certain current and voltage ranges is carried out in a
separate window for device configuration. This configuration has to be performed in an advance
operation.
 Make certain to note the available '$  current and voltage ranges of the before you
connect the analog devices.
 Analog devices that you use in ODEZRUOGVRIW have to be included in the device configuration
selection list.
 A maximum of four devices may be assigned to each '$  via the corresponding
designations.
The '$  parameter settings may be found under the following topics: