7lphu &rqwuro %orfn – IKA labworldsoft User Manual
Page 43
- 43 -
7LPHU &RQWURO %ORFN
The
7LPHU
control block generates up to 8 control signals with
TTL-Pegel
(0V / 5V).
The amount of time for the change of the output signal is specified with the times set under
3KDVH
and
3KDVH
.
Under
6WDUW6WRS
you can specify whether Phase 1 is started with TTL-High (5V) or TTL-Low
(0V).
This is where the number of cycles (1 cycle = 1 x Phase 1 & 1 x Phase 2) can be stipulated.
If the number of cycles is set to 0 then the timer will continue to run as long as the current
measurement is being performed.
Carry out the following instructions:
1. Call up the parameters window by double clicking on the icon.
2. If necessary, enter the
1DPH
of the timer into the "Module Name" text field.
3. Enter the time defaults for the two
3KDVHV
and the
6WDUW RU 6WRS &RQGLWLRQV
4. Specify the number of
&\FOHV
run through.
0XOWLFKDQQHO 2SHUDWLRQ
The ports should identifiable for multichannel operation. The ports may be identified for this
purpose.
Carry out the following instructions:
1. Set the
&KDQQHO &RXQW
by clicking the upper arrow keys.
2. Select the channel by clicking the lower arrow keys.
3. Enter the
&KDQQHO 'HVLJQDWLRQ
into the text field, i.e. make an entry for each channel
selected.
4. Set the
3KDVHV
,
6WDUW RU 6WRS &RQGLWLRQV
and the
&\FOH &RXQW
for the channel
selected.