0hwurkp s+,rq 0hwhu – IKA labworldsoft User Manual
Page 137
- 137 -
0HWURKP S+,RQ 0HWHU
pH/Ion Meter with automatic temperature compensation.
Determination of a primary measured value together with current temperature.
0HDVXUHG YDOXHV
1. pH – value
2. Temperature [°C]
3. Potential [mV]
4. Concentration
1RWHV
Please see Metrohm Instructions for Use for a detailed description of the instrument.
For proper communication, the pH/Ion Meter must be connected using a suitable RS232 cable
(Metrohm order No.: 6.2125.010). The RS232 settings at the pH/Ion Meter must be set to the
following parameters:
EDXG UDWH GDWD ELW VWRS ELW SDULW\ QRQH KDQGVKDNH +:V 56 FRQWURO 21
These are default values of the pH/Ion Meter configuration under:
&21),*56 VHWWLQJV
.
The response time of this instrument is 100 ms for each activated measured value. If both
channels are activated, the minimum sampling time is increased to 200 ms. If a lower sampling
time was chosen by the user, this value will be automatically adjusted by labworldsoft with the
beginning of the measurement.