0rqriors &rqwuro %orfn – IKA labworldsoft User Manual
Page 50
- 50 -
0RQRIORS &RQWURO %ORFN
The
0RQRIORS
control block is a
WLPHU ZKLFK LV WULJJHUDEOH VWDUWDEOH YLD D FRQWURO LQSXW
If a
change of the logic level from
TTL-Low
to
TTL-High
arises at the control input (
3RVLWLYH 6ORSH
) or
the opposite (
1HJDWLYH 6ORSH
), the level of the output for the
+ROG 7LPH
is switched.
The level of the output signal depends on the
/HYHO IRU +ROG 7LPH
setting. If
+LJK
is selected, the
level is in the untriggered state TTL-Low, and during the hold time TTL-High; if
/RZ
is selected,
the level is in the untriggered state TTL-High, and changes during the hold time to TTL-Low.
If the
5HWULJJHULQJ
option is activated, a new trigger pulse leads to a new start of the hold time; i.
e. if the hold time is greater than the spacing of the trigger pulse, the output remains permanently
set. In this way, it is possible, for example, to monitor a periodically occurring signal.
If
5HWULJJHULQJ
is not activated, incoming trigger pulses are ignored during the
+ROG 7LPH
. The
Monoflop can first be retriggered after expiration of the
+ROG 7LPH
.
Carry out the following instructions:
1. Call up the parameters window by double clicking on the icon.
2. If necessary, enter the
0RGXOH 1DPH
of the control block into the "Designation" text field.
3. Select
7ULJJHU
on
3RVLWLYH
or
1HJDWLYH 6ORSHV
4. Enter
+ROG 7LPH
.
5. Select
+ROG 7LPH /HYHO
.
6. Select
5HWULJJHULQJ
if required.
0XOWLFKDQQHO 2SHUDWLRQ
The ports should identifiable for multichannel operation. The ports may be identified for this
purpose.
Carry out the following instructions:
1. Set the
&KDQQHO &RXQW
by clicking the upper arrow keys.
2. Select the channel by clicking the lower arrow keys.
3. Enter the
&KDQQHO 'HVLJQDWLRQ
into the text field, i.e. make an entry for each channel
selected.
4. Select
7ULJJHU
on
3RVLWLYH
or
1HJDWLYH 6ORSHV
5. Enter
+ROG 7LPH
.
6. Select
7ULJJHU
on
3RVLWLYH
or
1HJDWLYH 6ORSHV
7. Enter
+ROG 7LPH
.
8. Confirm entries with
2.
.