Rockwell Automation 1336Z SPIDER - FRN 2.xxx-5.xxx - Manual (Page 11)

Chapter
2
General Installation for All Drives
Chapter 2 provides the information you need to properly mount and
wire the main power connections of 1336 SPIDER Drives. In
addition, installation instructions are provided for the communication
options (GM1, GM2, etc.). Detailed control and signal wiring for the
Stand-alone or PLC control version is presented in Chapter 3 or 4,
respectively. Since most start-up difficulties are the result of incorrect
wiring, every precaution must be taken to assure that the wiring is
done as instructed. All items must be read and understood before the
actual installation begins.
Mounting Minimum Mounting Requirements for Proper Heat Dissipation
(Dimensions shown are between drives or other devices)
!
ATTENTION: The following information is merely a
guide for proper installation. The Allen-Bradley
Company cannot assume responsibility for the
compliance or the noncompliance to any code, national,
local or otherwise for the proper installation of this drive
or associated equipment. A hazard of personal injury
and/or equipment damage exists if codes are ignored
during installation.
Normal Spacing
5.1 mm (0.2 in.)
15.2 mm (0.6 in.)
Required to
Remove Cover
101.6 mm
(4.0 in.)
101.6 mm
(4.0 in.)
101.6 mm
(4.0 in.)
101.6 mm
(4.0 in.)
UP
PWR
RUN
STOP
FAULT
TB1
TB2
TB3
TB4
TB5
TB6
TB7
DEVICE IS LIVE UP TO
180SEC AFTER REMOVING
MAINS VOLTAGE.
GERÄT FÜHRT BIS
180SEK NACH DEM
AUSSCHALTEN SPANNUNG.
L'APPAREIL RESTE SOUS
TENSION JUSQU'A 180 S
APRES LA MISE HORS SERVICE.
PE
DEVICE IS LIVE UP TO
180SEC AFTER REMOVING
MAINS VOLTAGE.
GERÄT FÜHRT BIS
180SEK NACH DEM
AUSSCHALTEN SPANNUNG.
L'APPAREIL RESTE SOUS
TENSION JUSQU'A 180 S
APRES LA MISE HORS SERVICE.
PE
PWR
RUN
STOP
FAULT
TB1
TB2
TB3
TB4
TB5
TB6
TB7
DEVICE IS LIVE UP TO
180SEC AFTER REMOVING
MAINS VOLTAGE.
GERÄT FÜHRT BIS
180SEK NACH DEM
AUSSCHALTEN SPANNUNG.
L'APPAREIL RESTE SOUS
TENSION JUSQU'A 180 S
APRES LA MISE HORS SERVICE.
PE