Rockwell Automation 1336Z SPIDER - FRN 2.xxx-5.xxx - Manual (Page 147)

Appendix
A
Specifications and
Supplemental Information
Appendix A provides specifications and supplemental information
including a parameter cross reference and derate information.
Specifications Protection
200-240V Drive 380-480V Drive
AC Input Overvoltage Trip: 285V AC 570V AC
AC Input Undervoltage Trip: 120V AC 240V AC
Bus Overvoltage Trip: 405V DC 810V DC
Bus Undervoltage Trip: 160V DC 320V DC
Nominal Bus Voltage: 324V DC 648V DC
Heat Sink Thermostat Monitored by microprocessor overtemp trip.
Drive Overcurrent Trip
Software Current Limit: 20 to 240% of [Rated Amps].
Hardware Current Limit: 125 to 270% of [Rated Amps].
Instantaneous Current Limit: 135 to 290% of [Rated Amps].
Line transients: Impulse with standard voltage (1.2/50 µ s):4000 volts per EN 50178.
Power Ride-Thru: 30 milliseconds at full load.
Logic Control Ride-Thru: 0.5 seconds minimum, 2 seconds typical.
Ground Fault Trip: Phase-to-ground on drive output.
Short Circuit Trip: Phase-to-phase on drive output.
Environment
Altitude: 1000 m (3300 ft) max. without derating.
Ambient Operating Temperature
IP20, NEMA Open Type: 0 to 50 degrees C (32 to 122 degrees F).
Storage Temperature: –40 to 70 degrees C (–40 to 158 degrees F).
Atmosphere Important: Drive must not be installed in an area where
the ambient atmosphere contains volatile or corrosive
gas, vapors or dust. If the drive is not going to be installed
for a period of time, it must be stored in an area where it
will not be exposed to a corrosive atmosphere.
Relative Humidity: 5 to 95% non-condensing, 75% average.
Shock: 15G peak for 11ms duration ( ± 1.0ms).
Vibration: 1G continuous.
Agency Certification:
1 Note: Installation guidelines called out in Appendix C must be adhered to.
U.L. Listed
CSA Certified
Marked for all applicable directives 1
Product Standards EN 61800-3
Emissions
EN 50081-1
EN 50081-2
EN 55011 Class A
EN 55011 Class B
Immunity EN 50082-1
EN 50082-2
IEC 801-1, 2, 3, 4, 6, 8 per EN 50082-1, 2
Low Voltage EN 60204-1
EN 50178

Q E T N O C D N I
6 L 6 5 D E T S IL

Q E T N O C D N I
6 L 6 5 D E T S IL