Rockwell Automation 1336Z SPIDER - FRN 2.xxx-5.xxx - Manual (Page 24)

2–14 General Installation for All Drives
Adapter Definitions and
Communication Option
Installation Serial communication devices such as the Human Interface Module
that are connected to the drive are identified by SCANport as
Adapters. Depending on the drive and options ordered, different
adapters are available. The communication options available for the
1336 SPIDER can be mounted as shown in Figure 2.2. Access to the
communication ports and LEDs is gained by removing the knockouts
shown. Figure 2.3 shows the maximum distance allowed between
external devices.
Figure 2.2
Adapter Locations
Figure 2.3
Remote Device Distances
(Remove Shaded Areas)
(Communication Board Installed)
(Installed)
(Remove Shaded Areas) (Installed)
DeviceNet
Remote I/O
Adapter 2
Adapter 1
PWR
RUN
STOP
FAULT
TB1
TB2
TB3
TB4
TB5
TB6
TB7
DEVICE IS LIVE UP TO
180SEC AFTER REMOVING
MAINS VOLTAGE.
GERÄT FÜHRT BIS
180SEK NACH DEM
AUSSCHALTEN SPANNUNG.
L'APPAREIL RESTE SOUS
TENSION JUSQU'A 180 S
APRES LA MISE HORS SERVICE.
PE
L1
L2
L3
45 (–)
47 (+)
48
U
V
W
J1 J3
J2
TB1
Slot A
Slot B
J8 J13 J1
1
Total cable distance between
each device and drive must
be 10 meters (33 feet) or less.
HIM or Other
Remote Device
JOG
ESC SEL
Length = X Meters
Cable Length in
Meters = 10 – X Cable Length in
Meters = 10 – X
Port Expansion
Option
(1203-SG2)
Maximum Cable
Length = 10 Meters
or
HIM or Other
Remote Device
JOG
ESC SEL
120/240V AC Input Communication Module
RIO
SCANport
Comm
Status PWR
RUN
STOP
FAULT
TB1
TB2
TB3
TB4
TB5
TB6
TB7
DEVICE IS LIVE UP TO
180SEC AFTER REMOVING
MAINS VOLTAGE.
GERÄT FÜHRT BIS
180SEK NACH DEM
AUSSCHALTEN SPANNUNG.
L'APPAREIL RESTE SOUS
TENSION JUSQU'A 180 S
APRES LA MISE HORS SERVICE.
PE
L1 L2 L3
45 (–) 47 (+) 48 U V W Expansion Options 1
1203-SG2
1203-SG4
2 3 4 5
2 3
1 Communications Port for remote HIM/communication options (Adapter 2) or Expansion Options (Adapters 2, 3, 4, 5) is located at TB1.