Rockwell Automation 1336Z SPIDER - FRN 2.xxx-5.xxx - Manual (Page 59)

Chapter
6
Start-Up
This chapter describes how you start-up the 1336 SPIDER Drive.
Included are typical adjustments and checks to assure proper
operation. The information contained in previous chapters of this
manual must be read and understood before proceeding.
Important: The 1336 SPIDER is designed so that start-up is simple
and efficient. Two start-up methods are provided. A self
prompting “assisted” procedure utilizing the 1336
SPIDER Startup mode. As an aid, this mode asks
questions about the most used basic parameters. The
second “advanced” method, provides a more complex
start-up utilizing the “Program” mode and complete
parameter access. Advanced features and adjustments are
grouped separately from basic parameters for ease of use.
Start-Up Requirements The following procedures are written for users who have a Human
Interface Module (HIM) installed at Adapter 2 (TB1) and who are not
using a 2-wire drive control scheme. For users without a HIM,
respective external commands and signals must be substituted to
simulate their operation.
Important:
• Power must be applied to the drive when viewing or changing
1336 SPIDER parameters. Previous programming may affect the
drive status when power is applied.
• Remote start circuits may be connected to TB4-TB6. Confirm
that all circuits are in a de-energized state before applying power.
External user supplied voltages may exist at TB4-TB6 even when
power is not applied to the drive. TB7 provides a 24V power
source.
• Refer to Chapter 8 for fault code information.
!
ATTENTION: Power must be applied to the drive to per-
form the following start-up procedure. Some of the voltages
present are at incoming line potential. To avoid electric
shock hazard or damage to equipment, only qualified ser-
vice personnel should perform the following procedure.
Thoroughly read and understand the procedure before be-
ginning. If an event does not occur while performing this
procedure, Do Not Proceed. Remove Power by opening
the branch circuit disconnect device and correct the mal-
function before continuing.