Rockwell Automation 1394 SERCOS Interface Multi-Axis Motion Control System Installation Manual User Manual
Page 29
Publication 1394-IN002B-EN-P — February 2004
Installing Your 1394 SERCOS Interface System
1-19
4.
5. Hang the AM50/75 axis module on the next mounting fastener.
6. Engage the alignment tab (refer to Figure 1.12).
Figure 1.12
Alignment Tab
If you are mounting a:
Do this:
1394x-AM03, -AM04 or -
AM07; 1394C-AM50-IH,
or -AM75-IH axis module
1. Hang the axis module on the next
mounting fastener.
2. Go to main step 6.
1394x-AM50 or -AM75
axis module with the
heat sink through the
back of the enclosure
(refer to Figure 1.4)
1. Remove the paper backing from
the gasket that came with the
AM50/75 axis module.
2. Position the gasket so that the
sticky side faces the axis module
and the small hole side is on top.
3. Slide the gasket over the heat sink
and attach it to the back of the axis
module.
Figure 1.11
Gasket Position
4. Go to main step 5.
gasket
Engaged alignment tab