Metrohm tiamo 1.0 Manual - Manual (Page 130)

106 Workplace
3.5 Subwindow Run
3.5.1 General
Subwindow Run
The subwindow Run contains the operating tools for controlling method runs and
managing sample data. It is always shown in the program part Workplace, i.e. it
cannot be removed from the Workplace view. The subwindow can be enlarged
and diminished as required; it can also be maximized.
Tabs
The subwindow Run consists of the two following tabs:
• Single determination
Controls single determinations.
• Determination series
Controls a determination series.
Note
If on the tab Single determination a sequence has been started ( Status <> REA-
DY ), then the tab Determination series cannot be accessed (inactive). The same
applies for the tab Single determination if a sequence has been started on the
tab Determination series .
3.5.2 Single determination
Overview
On the tab Single determination in the subwindow Run the parameters and sample
data for single determinations can be edited and run functions triggered. It in-
cludes the following tools and functions:
• Operating tools
Buttons for starting, stopping, interrupting and continuing determina-
tions.
• Status display
Shows the current status of the workplace.
• Determination parameters
Entry of general parameters for the determination.