Metrohm tiamo 1.0 Manual - Manual (Page 692)

668 Configuration
6.9.3 Rack properties
Rack name
Shows the name of the attached rack. If no rack is in position then " ----- " will
be shown.
Rack code
Shows the rack code of the attached rack. The rack code corresponds to
the arrangement of magnets on the base of the rack and is read in by the
Sample Processor in order to recognize the rack. If no rack is in position
then the display will be empty.
Number of positions
Shows the number of positions on the attached rack. If no rack is in posi-
tion then the display will be empty.
The parameters for the attached rack are defined on the following 3 tabs:
• Rack parameters
Defines the parameters that are valid for all rack positions.
• Lift positions
Defines the work, rinse, shift and special positions for Tower 1 and
Tower 2 (if present).
• Special beaker
Settings for all special beakers on the rack in position.