Metrohm tiamo 1.0 Manual - Manual (Page 483)

Commands 459
Note
Lower filling rates should be entered for solutions with higher viscosities.
Fill automatically
This parameter is only visible for devices of the type Titrando, Dosing Inter-
face and USB Sample Processor.
[ on ], off
The buret is automatically filled after dosing if this option is enabled. The
volume display is set back to
0.0000 mL while filling. The volume added is
displayed accumulative if this option is disabled.
LQH
Command for extensive dosing tasks with a Dosino (700 or 800).
Devices
This command can be executed with the following devices equipped with a Dos-
ino 700/800:
Titrando: 808, 809, 835, 836, 841
Dosing Interface: 846
Sample Processor: 778, 789, 814, 815
Appearance
The command has the following appearance:
Parameters
The parameters for the command LQH are configured on the following 2 tabs:
• General/Hardware
Parameters for the hardware.
• Parameters
Parameters for the Liquid Handling tasks.
General/Hardware