Metrohm tiamo 1.0 Manual - Manual (Page 669)

Subwindow Sensors 645
6.7 Subwindow Sensors
6.7.1 General
Subwindow sensors
The subwindow Sensors contains the Sensor table with all the configured sensors.
It can be shown in a separate window on the program part Configuration as a
part of the Configuration view or (if not present on the desktop) with View, Quick
access . The subwindow can be enlarged and diminished as required; it can also
be maximized.
Standard sensors
The sensor table contains the following sensors as standard; these cannot be de-
leted:
• Conductivity sensor
• ISE electrode (ion-selective electrode)
• Metal electrode
• pH electrode
• Temperature sensor
6.7.2 Sensor table
Contents
In the sensor table the following information about the configured sensors is
shown as standard:
Sensor name
Name of the sensor.
Sensor type
Type of the sensor.
Set to work
Date on which the sensor was used for the first time.
Expiry date
Expiry date of the sensor. If sensor monitoring is switched on and if the set
date is before the current date (i.e. the working life has elapsed) then the
date will be shown in red.
Slope
Slope of the sensor in % or mV.
pH(0)/E(0)
Electrode zero point of the sensor.
Next calibration
Date on which the next calibration is to be carried out. If calibration data
monitoring is switched on and if the set date is before the current date (i.e.