Metrohm tiamo 1.0 Manual - Manual (Page 162)

138 Workplace
The altered parameters apply until either the method is changed, the user logs out
or the program is closed. In such cases a message appears asking whether the
method alterations are to be saved. With [Yes] a new method version will be gen-
erated, with [No] the old method version will be retained.
If live parameters are altered then these alterations will be documented in both the
determination and the Audit Trail. In the parameter report for the determination all
parameters that have been altered are indicated by asterisk ( * ) and saved at the
end of the determination. If parameters of commands that have already been
processed are altered then these alterations will only become effective for the next
determination; however, they will nevertheless be indicated in the method report
for the finished determination as "live modification". As soon as the method has
been properly saved the markings will disappear.
Methods with modified live parameters can also be altered manually at any time in
the status
READY with File, Method, Save or File, Method, Save as... and then saved.
Note
Methods that have been signed at Level 2 and are therefore blocked cannot ha-
ve their live parameters edited.
Fields whose contents are defined by a formula cannot be altered live.
If an active
SEQUENCE command is canceled then only the individual command
in the sequence that is currently active will be canceled and the next individual
command will be started.
3.6.4 Quit command
If a workplace is in the BUSY status then the context-sensitive menu item Quit can
be used to stop the execution of an active command immediately and to jump di-
rectly to the next command. This only applies to commands with live display. This
cancellation is documented in the determination (under Messages) and in the Au-
dit Trail. The data and variables generated by the canceled command up to this
point will be saved.