3 sensor properties – Metrohm tiamo 1.0 Manual User Manual
Page 673
Subwindow Sensors
649
6.7.3 Sensor
properties
Edit properties
With the menu item
Edit, Properties...
in the subwindow
Sensors
the properties win-
dow for the sensor selected in the sensor table opens in which the parameters of
the sensor can be edited. It consists of the following tabs:
•
Sensor
General information about the sensor, such as sensor name, sensor
type, start up, etc.
•
Calibration data
Information about calibration of the sensor.
•
Limits
Definition of limits monitoring for slope and electrode zero point.
•
History
Shows the last 10 calibration values.
Sensor
Sensor name
24 characters
Name of the sensor.
Sensor type
Shows the type of sensor.
Ion
Shows the ion to be measured and its valency. This parameter only ap-
pears for
ISE electrodes
.
Order number
24 characters, [ 'empty' ]
It is possible to enter the order number of the sensor.
Sensor serial number
10 characters, [ 'empty' ]
It is possible to enter the serial number of the sensor.