Swing – Metrohm tiamo 1.0 Manual User Manual
Page 492
468
Method
SWING
Command for swinging the robotic arm. This command is only executable if the
Sample Processor is equipped with a 786 Swing Head with a robotic arm.
Devices
This command can be executed with the following devices:
Sample Processor: 778, 789, 814, 815
Appearance
The command has the following appearance:
Parameters
The parameters for the command
SWING
are configured in the following dialog
window:
•
SWING
SWING - properties
Command name
25 characters, [ Swing # ]
Name of the command.
Device
Device name
Device name, [ not defined ]
Selection of a device from the device table. Only those devices being able
to execute the command are selectable. Additionally,
not defined
can be se-
lected. In this case, the device name must be assigned by the user at the
start of the method.
Device type
Device types, [ 814 USB Sample Processor ]
Display or selection of the device type. If a device is selected under
Device
name
, this parameter is not editable any more. The device type belonging to
the selected device is displayed instead.