Scan – Metrohm tiamo 1.0 Manual User Manual
Page 517
Commands
493
SCAN
Command for scanning remote input lines.
Devices
This command can be executed with the following devices:
Titrino: 751, 758, 784, 785, 795, 798, 799
Titrando: 808, 809, 835, 836, 841, 846
Coulometer: 756, 831
Sample Processor: 730, 774, 778, 789, 814, 815
Appearance
The command has the following appearance:
Parameters
The parameters for the command
SCAN
are configured in the following dialog win-
dow:
•
SCAN
SCAN - Properties
Command name
25 characters, [ Scan lines # ]
Name of the command.
Device
Device name
Device name, [ not defined ]
Selection of a device from the device table. Only those devices being able
to execute the command are selectable. Additionally,
not defined
can be se-
lected. In this case, the device name must be assigned by the user at the
start of the method.
Device type
Device types, [ Titrando ]
Display or selection of the device type. If a device is selected under
Device
name
, this parameter is not editable any more. The device type belonging to
the selected device is displayed instead.