Metrohm tiamo 1.0 Manual - Manual (Page 499)

Commands 475
Command name
25 characters, [ Initialize rack # ]
Name of the command.
Device
Device name
Device name, [ not defined ]
Selection of a device from the device table. Only those devices being able
to execute the command are selectable. Additionally,
not defined can be se-
lected. In this case, the device name must be assigned by the user at the
start of the method.
Device type
Device types, [ 814 USB Sample Processor ]
Display or selection of the device type. If a device is selected under Device
name , this parameter is not editable any more. The device type belonging to
the selected device is displayed instead.
If the option
not defined is selected as Device name , all device types being
able to execute the command can be selected independently from the de-
vices in the device table.
Rack test
on, [ off ]
If this option is enabled, the rack attached will be checked.
Test rack
all sample racks listed in the configuration
Selection of the rack name for the rack which must be put on. In this way
you can ensure that the method can only be carried out with this rack. If
another sample rack is detected while executing the command, a message
is displayed and an Error track will be started if there is one defined.
HEATER
Command for controlling the oven temperature of the 774 Oven Sample Proc-
essor.
Devices
This command can only be executed with the 774 Oven Sample Processor.
Appearance
The command has the following appearance:
Parameters
The parameters for the command HEATER are configured in the following dialog
window:
• HEATER