Metrohm tiamo 1.0 Manual - Manual (Page 648)

624 Configuration
Stop determination
The running determination will be automatically terminated. The following
message must be confirmed with [OK] .
RS232 device
The parameters for a generic RS232 device are set on the following tabs:
• General
General device information such as device name, device type, serial
number, etc.
• RS232
Selects and configures the serial interface to which the device is con-
nected.
• GLP
Information about GLP test and GLP monitoring.
General
Device name
50 characters, [ device type number_# ]
Name of device (can be freely defined by user).
Device type
Shows the type of device.
Program version
Shows the program version of the device.
Opens the dialog window Load new program version . This button is only ac-
tive when the device has an old program version that is not supported by
tiamo which can be updated by tiamo itself.
Device serial number
Shows the serial number of the device.
Set to work
Shows the date on which the device was automatically added to the device
table.
Working hours
Shows the number of operating hours (only for 778, 789, 814 and 815 de-
vices).