Receive – Metrohm tiamo 1.0 Manual User Manual
Page 521
Advertising
Commands
497
RECEIVE
Command for awaiting event messages or status messages produced by
commands.
Appearance
The command has the following appearance:
Parameters
The parameters for the command
RECEIVE
are configured in the following dialog
window:
•
RECEIVE
RECEIVE- properties
Command name
25 characters, [ Receive # ]
Name of the command.
Wait for event/status
Wait until all conditions are met
[ on ], off
It will be waited as long as all conditions listed in the table below are ful-
filled.
Wait until one of the conditions is met
on, [ off ]
It will be waited as long as one condition listed in the table below is fulfilled.
Table with conditions
The table lists all conditions. It is not editable directly.
Advertising