Meas conc – Metrohm tiamo 1.0 Manual User Manual
Page 463
Commands
439
MEAS Conc
Command for concentration measurements (direct measurement).
Devices
This command can be executed with the following devices:
Titrando: 808, 809, 835, 836
Appearance
The command has the following appearance:
Parameters
The parameters for the command
MEAS Conc
are configured on the following 3
tabs:
•
General/Hardware
Parameters for device, sensor and stirrer.
•
Measuring parameters
Parameters for the measurement.
•
Additional measured values
Defining further measured values which can be saved as additional
columns in the list of measuring points.
General/Hardware
Command name
25 characters, [ MEAS Conc # ]
Name of the command.
The general parameters for the control device, the sensor and the stirrer are de-
fined on this tab.