Meas cond – Metrohm tiamo 1.0 Manual User Manual
Page 465
Commands
441
MEAS Cond
Command for conductivity measurements.
Devices
This command can only be executed with the 712 Conductometer.
Appearance
The command has the following appearance:
Parameters
The parameters for the command
MEAS Cond
are configured on the following 4
tabs:
•
General/Hardware
Parameters for device, sensor and stirrer.
•
Measuring parameters
Parameters for the measurement.
•
Evaluations
Defining further methods for evaluating measurement curves.
•
Additional measured values
Defining further measured values which can be saved as additional
columns in the list of measuring points.
General/Hardware
Command name
25 characters, [ MEAS Cond # ]
Name of the command.
The general parameters for the control device and the sensor are defined on this
tab.