Canon FAX-L1000 - Manual (Page 112)

2-56
FAX-L1000 Chapter 2: Operating Instructions
#3 NUMERIC PARAM. (numeric parameter settings)
No. Function Selection range Default setting
010 T0 Timer 0~9999 5500 (55 second)
011 T1 Timer (Rx) 0~9999 3500 (35 second)
013 Maximum time to receive 500~3000 1320 (13.2 second)
one line of image data
[No.010]
The “wait time after transmission of a dialing signal ends until a significant signal is
detected in transmission” was set as T1 timer with parameter 10. However, ITU-T
recommends that it should be set as T0 timer, so parameter 10 has been renamed to T0
timer and the default time-out time has been changed from 35 to 55 seconds.
NOTE
The T1 timer for the transmitter (wait time after a CED, V21 flag, or ANSam
significant signal is detected until the next significant signal is detected) is
fixed at 35 seconds.
[No.011]
Set the T1 timer for the receiver (wait time after DIS transmission starts until a significant
signal is received).
If frequent errors occur during reception because of line connection conditions, raise the
value of this parameter.
[No.013]
Set the maximum time to receive one line of image data when image data is received.
If the other party is a computer fax and the time to receive one line of image data is long,
raise the value of this parameter to increase the maximum reception time.