Canon FAX-L1000 - Manual (Page 327)

4-75
FAX-L1000 Chapter 4: Maintenance and Service
Recording paper is not picked up from the cassette 2 (Option paper feeder)
Solution: (1) Check that the cassette 2 is installed correctly.
(2) Check if more than the regulation amount of recording paper is loaded
in the cassette 2.
(3) Check that the cassette pickup roller is at its initial position. If it is not,
after switch the power on, insert the cassette 2 into the main unit.
(4) Clean the cassette pickup roller, cassette feed roller and cassette
separation roller.
(5) Check the cassette claw. If it is deformed, replace it.
(6) Check the cassette pickup solenoid and paper size detection board 2
(J802) connections.
(7) Check the resistance between cassette pickup solenoid (J802-1) and
(J802-2), which should be approx. 110 ohm. If it is not, replace the
cassette pickup solenoid.
(8) Check the pick-up module drive unit. If there are damaged parts,
replace any damaged parts.
(9) Check the option cassette paper size detection board 2 (J801), paper
feeder connector (J811, J812, J104, J106) and paper size detection
board 1 (J601) connections.
(10) Check the ECNT board (J72) and paper size detection board 1 (J603)
connections.
(11) Replace the cassette pickup roller.
(12) Replace the cassette feed roller and cassette separation roller together.
(13) If the FAX-L1000 Printer Kit is installed, make a test print from the
cassette 2. If the paper is picked up correctly, replace the FAX-L1000
Printer Kit.
(14) Replace the paper size detection boards.
(15) Replace the ECNT board.