Canon FAX-L1000 - Manual (Page 561)

5-203
FAX-L1000 Chapter 5: Appendix
3.7.3 Technical information
a) Specification
Interface 10Base-T Ethernet, 100Base-TX Ethernet
CPU TOSHIBA TMPR3904AF
LAN controller TOSHIBA TC35815AF
Transceiver TDK TSC78Q2120
Flash ROM 2MB
DRAM 2MB
×
2
Dimensions 139.5(W)
×
93.0(D)
×
24.7(H)mm (excluding mounting materials
and connector.)
Weight About 0.1kg
Power supply DC5V (supplied from the printer)
Protocol IPX/SPX, TCP/IP, AppleTalk, NetBIOS
Frame Type IPX/SPX:802.2, 802.3, Ethernet II, 802.2 SNAP, AUTO SENSE
TCP/IP:Ethernet II
AppleTalk:802.2 SNAP(Phase II)
NetBIOS:802.2
Print application IPX/SPX:NDS PServer, Bindery PServer, NPrinter, RPrinter
TCP/IP:LPD/UPP
AppleTalk:APS
NetBIOS:MPS
b) Operations
It is necessary to connect a FAX-L1000 Printer Kit to this board in order to use it. If the
board is connected, the main unit can be used as a network printer.
Characteristics of this board are as follows.
•Automatic switching interface for 10Base-T Ethernet and 100Base-TX Ethernet.
•Automatic switching and printing with the following protocols: IPX/SPX(Netware), TCP/
IP, AppleTalk, NetBEUI(NetBOIS).
•Device configurations and management are supported over Telnet and NetSpot, a graphical
user interface and SNMP-based printer management utility shipped with the product which
supports Windows98, 95, WindowsNT, Solaris 2.X, and Macintosh platforms.
•Can generate a Test Print which lists the current protocol configuration of the ethernet
board and send it to the connected printer.
•Firmware of the ethernet board is upgradable with NetSpot.