Canon FAX-L1000 User Manual
Page 308
4-56
FAX-L1000 Chapter 4: Maintenance and Service
(21) Check the recording paper eject sensor 2, the cable and the fixing unit
(J131) connections.
(22) Replace the recording paper eject sensor 2.
(23) Replace the ECNT board.
(24) Replace the ECNT board. (Recording paper eject sensor 1 defect)
#0021 [RX] DCN received during polling reception
Cause:
No subaddress/password set in other machine.
Solution:
Contact the other party and check subaddress/password of the other party.
#0025 [TX/RX] Automatic dialing setting error
Cause:
An attempt was made to auto dial with confidential and relay set in auto
dialing.
Solution:
Set confidential and relay correctly for auto dialing.
#0039 [TX] Closed network transmission not possible
Cause:
The closed network transmission switch is switched off.
Solution:
Set Service Data #1 SSSW SW07 bit 7 to “1” to switch on closed network
transmission.
Cause:
The other fax’s closed network transmission switch is switched off.
Solution:
Have the other party switch on the closed network reception switch on
their fax.
Cause:
The closed network ID does not match the other fax’s.
Solution:
Use Service Data #1 SSSW SW08 to set the same closed network ID for
your fax and for the other fax.
#0056 [RX] Faulty recording paper feeding
Cause:
The recording paper jammed when both the pre-feed sensor and the
recording paper eject sensor were OFF.
Solution:
Recover recording paper jam.
#0057 [RX] Faulty recording paper feeding
Cause:
The recording paper jammed when the pre-feed sensor was ON and the
recording paper eject sensor was OFF.
Solution:
Recover recording paper jam.
#0058 [RX] Faulty recording paper feeding
Cause:
The recording paper remains fixed when the recording paper eject sensor
is ON.
Solution:
Recover recording paper jam.