Canon FAX-L1000 - Manual (Page 413)

5-55
FAX-L1000 Chapter 5: Appendix
b-4) Check after DRAM boards installation
After installing the DRAM boards, carry out the following procedure to ensure that the
DRAM boards are properly identified by the fax.
(1) Referring to the flow chart, enter test mode D-RAM test [1].
Figure 5-11 Flowchart of D-RAM test 1
(2) When D-RAM test [1] is entered, check the D-RAM write-in and read-out. Confirm
that the display shows the extended memory capacity value, and that the check
completes with “
no error ”.
Figure 5-12 D-RAM Board Installation Check
(3) After confirming this, push the Stop button, then push the Clear button, which will
put the machine into a standby condition.
(4) If the process does not complete normally, return to b-3) Attaching memory
boards , re-attach the memory board, and then re-check with the D-RAM test.
Data Registration
Set
#
SERVICE MODE
TEST MODE
SERVICE MODE
#1 SSSW
TEST MODE [1]-[9],[#]
CFYA: (ROM Ver)
1
1: D-RAM 11648K
[1] --- [2]
1
1: D-RAM 11648K
✱✱✱✱
Display TEST MODE by
pressing
or button
1:D-RAM 11648K
1:D-RAM 11648K
complete (no error)
Indicates memory capacity
(4MB option memory: 7552 Kbytes)
(8MB option memory: 11648 Kbytes)