Hardy HI 3010 Filler/Dispenser Controller - Manual (Page 27)

HI 3010 Filler/Dispenser/IBC 14
User Guide
FIG. 3-7 SELECTION ALERT DISPLAY
Filling Procedures
About Filling
The Filling Operation is a Gain-in-Weight process. The
Filler controller measures the weight gain into a vessel until
the pre-set, weight set point has been reached. The Filler
controller then stops filling and automatically goes to a wait
condition waiting for the next container to be positioned for
filling. Once the new container is positioned the Filler begins
the process over again. The Hardy Filler/Dispenser enables
both single speed and dual speed filling including sequential
and simultaneous modes of operation.
Prefill Procedures
Step 1. Check to be sure that the first container is in posi-
tion for filling.
Step 2. Check to see if the Filler is configured for your spe-
cific filling application. If it is not you will have to
configure the instrument. For configuration proce-
dures please refer to the HI 3000 Service/Installa-
tion Manual for instructions.
Step 3. Check to see if the instrument is in the Standby
mode. The Standby Display should appear in the
display with an ingredient listed. (See Fig. 3-8)
FIG. 3-8 STANDBY DISPLAY
Enter The User ID
Step 1. Press the User button. The User Menu appears. (See
Fig. 3-9)
FIG. 3-9 USER MENU
Step 2. Press the Clear button to erase the current entry.
Step 3. Use the Alphanumeric buttons to enter your user
ID. A user ID is three (3) characters long and can
consist of Alphanumeric characters.
Some examples:
• Joe
• 312
• J15
• JD7
Step 4. Press the Enter button to set the New User.
Filling - Single Speed
NOTE: The values are used for illustration purposes
only, your requirements may vary.
Step 1. If the ingredient is the ingredient you want. Go to
Step 3.
Step 2. If the ingredient that appears in the Standby Menu
is NOT the ingredient you want, do the following:
• Press the Ingr./1 button once. The Ingredi-
ent Menu appears with the ingredient
number that appears on the Standby Dis-
play. (See Fig. 3-10)
FIG. 3-10 INGREDIENT MENU
• You can change the ingredient number two
ways.
1. Press the left or right arrow buttons to
select the ingredient number you
want.