Hardy HI 3010 Filler/Dispenser Controller - Manual (Page 33)

HI 3010 Filler/Dispenser/IBC 20
User Guide
NOTE: If you want to Stop the auxiliary function press
the Stop button two times.
Filling - Dual Speed
About Dual Speed Filling
Dual speed filling involves two fill rates, Fast and Slow
Sequential and Fast and Slow Simultaneous.
• For Sequential filling the Fast fill rate rap-
idly fills material into a vessel up to a pre
set weight set point. At that point the slow
fill rate begins to slowly fill the container
to the target weight.
• For Simultaneous filling the Fast and Slow
fill rates start simultaneously until the fill
material reaches a preset weight set point
for fast fill, at which time the Fast fill
stops. The Slow fill continues to slowly fill
the vessel to the target weight.
Most of the Steps and alarms for the Dual Speed Filler are
the same as the Single Speed Filler except for the following:
Dual Speed (Simultaneous)
• Once filling begins, the Fast Fill Display
appears. (See Fig. 3-37)
FIG. 3-37 FILL DISPLAY FAST FILL ON
• Even though only Fast Fill is displayed the
slow fill is operating.
• When Fast Fill reaches the Fast Fill Set
Point, it shuts off.
NOTE: The “Fast Fill” appears for both Single or Dual
Speed Filling.
FIG. 3-38 SLOW FILL DISPLAY
• The slow fill continues until the gain in
weight reaches the Target Window. (See
Fig. 3-38)
Dual Speed Sequential
• Once filling begins, the Fast Fill Display
appears. (See Fig. 3-39)
FIG. 3-39 FILL DISPLAY FAST FILL ON
• When the Fast Fill reaches the Fast Fill Set
Point, it shuts off.
NOTE: The “Fast Fill” appears for both Single or Dual
Speed Filling.
FIG. 3-40 SLOW FILL DISPLAY
• The slow fill starts and operates until the
gain in weight reaches the Target Window.
(See Fig. 3-40)
Pausing Fast Fill
• To pause the Fast Fill, press the Stop but-
ton once. (See Fig. 3-41)
FIG. 3-41 FAST FILL HOLD
• To resume Fast fill press the Start button.