Hardy HI 3010 Filler/Dispenser Controller - Manual (Page 29)

HI 3010 Filler/Dispenser/IBC 16
User Guide
FIG. 3-16 TARGET WT/NEW VALUE
• Press the Enter button. The Standby Menu
appears with the new Amount Required. In
our example we used 225 lbs. (See Fig. 3-
17)
FIG. 3-17 STANDBY MENU/NEW AMOUNT
REQUIRED
Step 5. If the number of fills is the number you want, go to
Step 7.
Step 6. If you want to change the number of fills, do the
following:
NOTE: 1 Fill = 1 Cycle. Fills and Cycles are used inter-
changeably.
• Press the Cycle/7 button. The Choose
Cycles Menu appears. (See Fig. 3-18)
FIG. 3-18 FILLS MENU
• You can change the number of bills two
ways:
1. Enter the number by using the Alpha-
numeric keypad without pressing the
Clear button.
2. Press the Clear button to erase the val-
ues displayed, then use the alphanu-
meric keypad to enter the new target
weight. (See Figs. 3-19 & 3-20)
FIG. 3-19 FILLS MENU/ERASED VALUES
NOTE: You can enter values from 1 - 9999.
FIG. 3-20 FILLS MENU/NEW FILLS NUMBER
• Press the Enter button. The Standby Menu
appears with the new cycles value. (See
Fig. 3-21)
FIG. 3-21 STANDBY MENU/NEW FILLS NUMBER
Step 7. Press the Start Button.
NOTE: When you Press the Start button to begin the fill-
ing process. The Standby Display changes and
shows that the instrument is on and waiting to
Fill (See Fig. 25). The instrument automatically
checks for motion, autozeros the scale, and auto-
tares the scale. If the Initial Auto Refill function is
turned ON the instrument begins checking to see
if there is enough material in the vessel. The Auto
Refill is user selectable. For configuration infor-
mation see the HI 3010 Installation and Service
Manual for instructions.
• If the material is below the high level
mark, the instrument begins to refill the
vessel. The Refill display appears. the