Hardy HI 3010 Filler/Dispenser Controller - Manual (Page 49)

HI 3010 Filler/Dispenser/IBC 36
User Guide
Step 5. If the number of dispenses is the number you want,
go to Step 7.
Step 6. If you want to change the number of dispenses, do
the following:
NOTE: 1Dispense = 1 Cycle. Dispenses and Cycles are
used interchangeably.
• Press the Cycle/7 button. The Choose Dis-
pense Menu appears. (See Fig. 4-18)
FIG. 4-18 CHOOSE DISPENSE MENU
• You can change the Dispense number two
ways.
1. Do not Press the Clear button and
press on the Alphanumeric keypad
number buttons which will replace the
existing values.
2. Press the Clear button to remove the
current Dispense number. (See Fig. 4-
19) Use the Alphanumeric buttons to
enter the new Dispense number. For
example enter the number 23 for the
berries ingredient (See Fig. 4-20)
FIG. 4-19 DISPENSE MENU/ERASED VALUES
NOTE: You can enter values from 1 - 9999.
FIG. 4-20 DISPENSE MENU/NEW DISPENSES
NUMBER
• Press the Enter button. The Standby Menu
appears with the new cycles value. (See
Fig. 4-21)
FIG. 4-21 STANDBY DISPLAY/NEW DISPENSES
NUMBER
Step 7. Press the Start button.
• When you Press the Start button to begin
the dispensing process, the Standby Dis-
play changes and shows that the instru-
ment is on and waiting to dispense. (See
Fig. 4-22)
FIG. 4-22 DISPENSE WAITING/ON
Auto Refill Sub-Routine
The Dispenser has two refill conditions:
Initial Refill - When you configure the Dispenser (See The
HI 3010 Service Manual) you set a Refill High set point. The
Dispenser checks at the beginning of the first cycle if the
Dispenser vessel has enough material to complete all the
cycles for this ingredient. If not it refills the Dispenser vessel
to the Refill High set point and does not check the refill
again until the material level is less than the required dis-
pense weight.