Hardy HI 3010 Filler/Dispenser Controller - Manual (Page 34)

21 CHAPTER 3
Filler
Pausing Slow Fill
• To pause the Slow Fill, press the Stop but-
ton once. (See Fig. 3-42)
FIG. 3-42 SLOW FILL HOLD
• To resume Slow fill press the Start button.
List of Fill Alarms
Not OK to FILL Alarm
- - - - - ALARM CONDITION - - - - -
• If the function is turned on and it is NOT
OK TO FILL, an alarm appears in the dis-
play. (See Fig. 3-43)
FIG. 3-43 NOT OK TO FILL
1. The Operator needs to determine why
it is NOT OK to FILL by checking for
problems with the electrical and /or
mechanical systems.
2. Once the problem has been fixed,
push the Clear button to clear the
Alarm. The Filler/Dispenser returns to
the standby mode awaiting a Start
Command.
NOTE: The OK to Fill Timer has a preset time to deter-
mine if it is OK to Fill. If the OK to Fill times out,
it means that the preset time may be too short for
the process and the NOT OK to FILL Alarm
appears with no real alarm conditions. You may
need to reset the timer if it appears that no elec-
trical or mechanical reason for the alarm is
determined. The OK to FILL timer may be set
incorrectly for your process. See the HI 3010 Ser-
vice Manual for Instructions on setting the OK to
FILL Timer.
Lost OK to Fill Alarm
- - - - - ALARM CONDITION - - - - -
During the filling process, conditions may develop that
cause the Filler/Dispenser to lose the OK to FILL during
Fast Fill or Slow Fill. When this occurs an alarm appears that
says LOST OK TO FILL. (See Figs. 3-44 & 3-45)
FIG. 3-44 LOST OK TO FILL ALARM/FAST FILL
FIG. 3-45 LOST OK TO FILL ALARM/SLOW FILL
1. The Operator needs to determine why
the system LOST OK to FILL by
checking for problems with the elec-
trical and /or mechanical systems.
2. Once the problem has been fixed,
push the Clear button to clear the
Alarm.
3. If the OK to FILL was lost while in
the fast or slow fill mode a display
asking if you want to Resume the Fast
Fill (See Fig. 3-46) or the Slow Fill
(See Fig. 3-47). If you want to resume
the Fast or Slow fill press the Start
button. If you do not want to resume
the fill press the Stop button which
takes you back to the Standby mode
and does not complete any more
cycles.
FIG. 3-46 RESUME FILLING FAST