Hardy HI 3010 Filler/Dispenser Controller - Manual (Page 40)

27 CHAPTER 3
Filler
FIG. 3-71 DISCHARGE ON ALARM
1. Check to see what is causing the prob-
lem.
2. Correct the problem.
3. Press the Clear button to clear the
alarm.
4. The CLOSE DISCHARE MANU-
ALLY display appears. After you
manually close the discharge, press
the Start button. (See Fig. 3-72)
FIG. 3-72 CLOSE DISCHARGE MANUALLY
5. The instrument returns to the Fill On
display or the Standby Display
depending on the filling cycle.
Operating the Filler from the Ethernet
(Web Site)
Getting Started
Step 1. Make sure you have installed the Ethernet cable
between your computer and the instrument.
Step 2. Open the browser on your computer.
Step 3. In the URL Address field type the IP Address of
the HI 3010 you want to operate (For complete
instructions see the Cabling/Installation section
of this manual). The Filler/Dispenser Home Page
appears. (See Fig. 3-96)
FIG. 3-73 FILLER/DISPENSER HOME PAGE/
SELECTING OPERATIONS
Step 4. Click on “Operations”. When entering Opera-
tions for the first time after cycling the power off/
on, an Alert asking for a User Name and Pass-
word appears. (See Fig. 3-97)
FIG. 3-74 ENTERING USER NAME AND PASSWORD
Step 5. Enter the User Name and Password and click
OK. The Operation Page appears. (See Fig. 3-98)
NOTE: When you enter the user name and password at
the beginning of each session, you won’t have to
enter it again for the session.