Hardy HI 3010 Filler/Dispenser Controller - Manual (Page 61)

HI 3010 Filler/Dispenser/IBC 48
User Guide
1. Check to see what is causing the Not
OK to discharge alarm to appear.
2. Correct the problem.
3. Press the Clear button to clear the
alarm. If auto discharge is on the dis-
penser looks for an OK to Discharge
signal. If the OK to Discharge is Off
the awaiting Command to Discharge
display appears. (See Fig. 4-76)
FIG. 4-76 AWAITING COMMAND TO DISCHARGE
No Discharge Alarm
- - - - - ALARM CONDITION - - - - -
• If the instrument determines that the dis-
charge did not occur, the NO DIS-
CHARGE alarm appears. (See Fig. 4-77)
FIG. 4-77 NO DISCHARGE ALARM
1. Check to see what is causing the no
discharge condition.
2. Correct the problem.
3. Press the Clear button to clear the
alarm. The Awaiting Command to
Discharge display appears.
Discharge On Alarm
- - - - - ALARM CONDITION - - - - -
• If the Discharge gate valve or feeder does
not close or turn off, a DISCHARGE ON
ALARM appears. (See Fig. 4-78)
FIG. 4-78 DISCHARGE ON ALARM
1. Check to see what is causing the dis-
problem.
2. Correct the problem.
3. Press the Clear button to clear the
alarm.
4. The CLOSE DISCHARGE MANU-
ALLY display appears. Manually
close the Discharge and press the Start
button.
5. The instrument returns to the Dis-
pense On display or the Standby Dis-
play depending on the dispensing
cycle.
Operating the Dispenser from the Ethernet
(Web Site)
Getting Started
Step 1. Make sure you have installed the Ethernet cable
between your computer and the instrument.
Step 2. Open the browser on your computer.
Step 3. In the URL Address field type the IP Address of
the HI 3010 you want to operate (For complete
instructions see the Cabling/Installation section
of this manual). The Filler/Dispenser Home Page
appears. (See Fig.4-103)
FIG. 4-79 FILLER/DISPENSER HOME PAGE/
SELECTING OPERATIONS