Installation of wall mount model -7 – Hardy HI 2151/30WC Single-Scale Controller User Manual
Page 37
Chapter 3 - Installation
3-7
Step 2.
Connect the 60-inch, 40-pin ribbon cable to the 40-pin con-
nection J5 on the electronics and the 40-pin connection J4 at
the rear of the front panel display.
Step 3.
Remote panel mechanical installation is complete.
NOTE:
The electronics can be mounted on any of the four sides.
Installing the HI
2151/30WC-BR Blind
Remote Model
Step 1.
Place the instrument in the enclosure so that there is two
inches of clearance from the each end of the enclosure.
Step 2.
Drill four .156 inch either tapped or thru holes and use four 6-
32 pan head machine screws to fasten the instrument to the
enclosure. (See Fig. 3-5)
NOTE:
The enclosure can be mounted on any four (4) of the six (6) sides.
Installing the HI
2151/30 Wall Mount
Model
Step 1.
Make sure that all Electrostatic Discharge (ESD) precautions
have been taken.
Step 2.
Mount the Instrument securely using all four mounting points.
(See Fig. 3-6)
FIG. 3-6 INSTALLATION OF WALL MOUNT MODEL
Step 3.
To conform to NEMA 4 or 4X ratings, connections to the
enclosure must be made with NEMA 4 or 4X conduit fittings.
Step 4.
Do not route any signal, voltage or ground wires under or
between printed circuit boards.