Hardy HI 2151/30WC Single-Scale Controller - Manual (Page 38)

HI 2151/30WC MANUAL
3-8
Step 5. Route wiring types through enclosure as shown in Fig. 3-7)
FIG. 3-7 WIRE ROUTING FOR WALL MOUNT MODEL
WARNING DO NOT MOUNT THE HI 2151/30WC CONTROLLER NEAR A HIGH MAG-
NETIC FIELD OR 120 VAC POWER SOURCE. ROUTE RIBBON CABLE A
MINIMUM OF 3 INCHES FROM ANY AC VOLTAGE CONDUCTING
CABLES. TO DO SO WILL EFFECT THE PERFORMANCE OF THE CON-
TROLLER AND MAY RESULT IN PROPERTY DAMAGE.
Electrical Installation
Cabling and
Interconnecting
Recommended
Installation
Procedures 1. Carefully plan the cable runs and wiring connections before rout-
ing, cutting and trimming cables and wires.
CAUTION INSTRUMENT POWER AND RELAY WIRES SHOULD BE ROUTED AWAY
FROM ALL OTHER SIGNAL CABLES TO AVOID ELECTRICAL INTER-
FERENCE.
2. All cabling should be neatly bundled, tied, and dressed.
3. Use a 6-inch service bend to relieve stress on the connectors and to
ease servicing the unit.
4. Make sure that all plugs are firmly in place.
5. Secure the power cord with the two captive screw-on clips.
6. All connections are made at the rear panel of the weight controller.