Profibus interface card option wiring diagram -24, Installation of the secure memory module -24 – Hardy HI 2151/30WC Single-Scale Controller User Manual
Page 54
HI 2151/30WC MANUAL
3-24
Profibus Interface
Card Option Wiring
Diagram
Step 1.
Connect P/N 0509-0390 ribbon cable between relay option
board jack J1 and J4 on the rear panel of the HI 2151/30WC.
(See Fig. 2-12)
Step 2.
For -WS wall mount versions the card can be mounted within
the enclosure. Route the wiring to J3 thru J8 via the lower left
side of the access hole.
For more complete instructions, see the Profibus Interface Option, Card
Operation and Installation Manual #0596-0211.
Installation of the Secure
Memory Module
FIG. 3-21 SECURE MEMORY MODULE
Step 1.
Make sure that the module has the notch facing up. (Fig. 3-21)
Step 2.
Slide the module with the notch up into the module housing.
Step 3.
Press the module in until it stops.
Step 4.
To remove the module pull the module straight out of the
housing. (See Fig. 3-22)
FIG. 3-22 INSTALLING AND REMOVING THE SECURE MEMORY
MODULE