Hardy HI 2151/30WC Single-Scale Controller - Manual (Page 66)

HI 2151/30WC MANUAL
5-2
weight). You can also type in the Tare Value by using the 1/Tare Val
key.
• The Tare function can also be actuated by activating the appropriate
remote function pin. See Remote Function Configuration in Chap-
ter 4.
Print Transmits data to the printer.
NOTE: The serial port must be configured as a printer. If the serial port is not configured as a
printer port, the print key is not going to respond, and you cannot print.
NOTE: The print function cannot print data if the weight is in motion or exceeds the capacity
of the scale.
—/Test/Clr • The Test/Clr function Initiates one of the selected tests
• Self Test - "SLFTST" on the display.
• Integrated Technician - "IT SEC" on the display.
• This (—) key is used to enter a minus sign (-) for a negative num-
ber. This function can be used only when the display reads the num-
ber 0.
• The clear "CLR" function is operable when the controller is a menu
requiring a numeric input. Use CLR to clear the display before
entering a new value.
1/Tare Val • This function displays the current Tare value stored in the Tare Reg-
ister. (See paragraph 5.1.3)
• This function allows the user, after pressing the "Clr" button, to
enter a Tare Value using the numeric keys. To exit the Tare Val
menu press the Zero button.
• The key also enters the digit "1."
2/Status/Bar • The Status/Bar toggles between the mode settings and the bar
graph.
• The Status function indicates the following:
• Selected Mode
• Selected Engineering Unit: lbs/kg
• Status of Relays 1 & 2
• The Bar Graph function displays in graphical form the value of the
mode (Total, Gross, Net, ROC, Peak) selected in the bar graph
setup menu. (See Fig. 5-2)
NOTE: The bar graph mode and the display mode are totally independent. Make sure you
know what mode each are in before reading.
• The key also enters the digit "2."