PRG Vx76 User Manual 3.6 - Manual (Page 114)

98 VX76 SOFTWARE USER MANUAL
Sneak Operation
Sneak values are entered using the [Sneak] button and either the Timing Filter or Function Filter screen. After the
sneak operation has been defined, pressing the Timing Filter’s

ENTER

button or the Function Filter’s

TO CUE

button will cause all selected luminaires to move into the new position as defined by the values. The values are
entered numerically at the keypad.
Perform a sneak action using current timing information:
Step 1. Select channels as required.
Step 2. Bring up either Timing Filter or Function Filter screen.
Step 3. Select parameter to be changed.
Step 4. At keypad, press [Sneak] and enter required value, press [Enter].
Step 5. At filter, select next parameter and enter its value using keypad.
Step 6. When finished, press Timing Filter’s

ENTER

button or Function Filter’s

TO CUE

button. Selected
luminaires will move into the new position as defined by the values.
Sneak to a preset (same for color and beam):
Step 1. Select channels as required.
Step 2. Bring up either Timing Filter or Function Filter screen.
Step 3. Select parameter to be changed.
Step 4. At keypad, press [Sneak] [Preset] [x] [Enter] (where x is the discrete preset number) or press and hold
[Sneak] while pressing

Preset Palette Button

.
Step 5. Press Timing Filter’s

ENTER

button or Function Filter’s

TO CUE

button. Selected luminaires will move
into the new position as defined by the preset data.
To Sneak Cue data:
Step 1. Select channels as required.
Step 2. Bring up either Timing Filter or Function Filter screen.
Step 3. Select parameter to be changed.
Step 4. At keypad, press [Sneak] [Cue] [x] [Enter] (where x is discrete cue number).
Step 5. Press Timing Filter’s

ENTER

button or Function Filter’s

TO CUE

button. Selected luminaires will move to
the cue selected.
Note: Cue numbers with decimals can be entered into sneak. For example, [Sneak] [Cue] [1] [.] [3] [Enter] will enter
Cue 1.3 into the selected parameter. Even cues without a decimal value will be displayed as a decimal value (1 is
1.00).
Note: Sneak cue data will recall data only for the selected parameters from the given cue, which can be used as a
selective recall tool.
Perform a sneak action using new timing information:
Step 1. Select channels as required.
Step 2. Bring up either Timing Filter or Function Filter screen.
Step 3. Select parameter to be changed.
Step 4. At keypad, press [Sneak] and enter required value, press [Enter].
Step 5. To enter time, press [Sneak] [Time] and time value. Press [Enter].
Step 6. Press Timing Filter’s

ENTER

button or Function Filter’s

TO CUE

button. Selected luminaires will move to
their new values using their time settings.