PRG Vx76 User Manual 3.6 - Manual (Page 378)

362 VX76 SOFTWARE USER MANUAL
MIDI Show Control Output
MIDI show control output can be useful to sync two consoles using MIDI. When enabled, if a cue is recalled in a
submaster, the console will output MIDI signals through its MIDI port.
To enable this feature, select any option other than the "Off" in the Settings/MIDI window. If "All Submasters" is
selected, MIDI show control output will be active for all submasters. If "Submaster 1 Only" is selected, MIDI show
control output will be active for Submaster 1 only.
The MIDI output options are configured using the Settings window.
To configure MIDI show control output:
Step 1. Select Settings from the Setup menu.
Step 2. Click Midi tab.
Step 3. At MIDI Output, configure device/port and other settings.
MIDI Show Control Message Format
When a Cue Number is sent as data, additional informational fields may or may not be included as part of the
complete "Cue Number" description. The option selected in the "Options" area of the MIDI window will determine
how much data will be sent with the Show Control "Go" command.
The MIDI show control fields are used as follows:
The stack and cue number (<Q number> field) is sent in "n.n.n" format. For example, cue 2-1.5 would be sent as
2.1.5.
The console will accept a value
of either 1 or 127 for input
Go Command Output Options -
see "Message Format" below
Select MIDI Output Device/Port
MIDI Show Control
Output Settings
<Q number> 00 <Q list> 00 <Q path> F7
Stack & Cue #
Submaster #
not used on output