From keypad, Guidelines, Order – PRG Vx76 User Manual 3.6 User Manual
Page 72
56
VX76 SOFTWARE USER MANUAL
From Keypad
Channels may also be selected using the command-line keypad, available on the front panel.
Guidelines:
+
Any combinations of [ + ], [ - ], and [Thru] are
allowed.
+
Pressing [Enter] completes the channel selection.
+
Because the keypad always defaults to channel
entry mode, use of the [Chan] (channel) button is
optional.
Select a single channel:
+
<Chan> [n] [Enter].
Select multiple channels:
+
<Chan> [m] [+] [n] [Enter].
Select a range of channels:
+
<Chan> [m] [Thru] [q] [Enter].
Select multiple channels including a group:
+
<Chan> [m] [+] [Group] [n] [Enter].
Select all active channels:
+
[Chan] [Enter].
Other examples:
+
<Chan> [m] [+] [s] [Thru] [w] [Enter].
+
<Chan> m] [+ ] [s] [Thru] [w] [-] [t] [Enter].
[Clear]
[Clear] functions as a backspace key when used during command-line construction. For example, <Chan> [n] [Thru]
[t] [Clear] [s] [Enter] results in the selection of channels n thru s. When [Clear] is used after an [Enter] (fully terminated
command line), the command line is cleared.
The only thing that clears a syntax error on the command line is [Clear]. Any other keypad entry is ignored until the
error condition is cleared.
Holding down [Clear] will clear an entire unterminated command line.
Note: The
order
of channel selection is retained when storing a Group. Refer to
Shift
Option
Cmd
1
2
3
.
0
Clear
At
Enter
Full
7
8
9
Time
4
5
6
Sub
Rate
Link
+
Thru
-
Loop
Force
Mark
Cue/
Delay/
Speed
Track
Back
Track/
Wait/
Trail
Sneak
Label
Move
Delete
Copy/
Sel
Park/
Patch
Undo
Recall
Store
Unpark
Update
Grab
Help
Query/
Store
Block/
UnBlk
Revert
Manual/
Effect
Set
Seq
Dynam
Group
Step
Snap
Beam
Color
Preset
Macro
Shot
Chan
Cue/
Stack
Board
Cue
ready (channel)
Tip