PRG Vx76 User Manual 3.6 - Manual (Page 375)

VX76 SOFTWARE USER MANUAL 359
MIDI SHOW CONTROL
Overview
The console can utilize MIDI Show Control (MSC) commands for more advanced external MIDI control. This section
covers commands as they relate to Vx76 functions. For more information on MIDI and MSC, consult the following
document available from MIDI Manufacturers Association (MMA):
+ The Complete MIDI 1.0 Detailed Specification
Midi Manufacturers Association
P.O. Box 3173
La Habra, CA 90632-3173
www.midi.org
The console has two options that must be defined before using MSC:
+ The MIDI ID is the device ID of the external device. This value can be defined as anything from 0-126. The system
will accept an incoming value of 127 for an "All Call." The MIDI ID default is zero. The MIDI ID of the console must
match the external device ID at the MIDI show controller.
+ The "Go #" Action selection, allows you to define if the "Go #" Action will take place for a Submaster or for a
Board Cue.
To configure MIDI show control input:
Step 1. Select Settings from the Setup menu.
Step 2. Click Midi tab.
Step 3. Select MIDI input device/port.
Step 4. At Show Control box, input MIDI ID (0-126). Refer to external controller.
Step 5. Select Sub 1 or Board Cue from the "Go #" Action.
When using MIDI Notes
feature, these buttons
select which MIDI channel
it will "listen" to (1-16).
Show Control Settings
Select MIDI Output Device/Port