PRG Vx76 User Manual 3.6 - Manual (Page 244)

228 VX76 SOFTWARE USER MANUAL
SNAPSHOTS
Overview
A snapshot is a captured state on the console which can be recalled at any time in the future. States such as Channel
Select panel selections, touchscreen status, submaster setups, and windows layouts can be captured as a snapshot.
Snapshots can be recalled via manual selection of the associated snapshot number or by automated activation
through the cue sheet via link instructions. Snapshots may also be included in macros.
Snapshots can be stored using the Snapshot Filter window or front panel touchscreen. The graphic interface allows
you to select those areas of the console you wish to include in a snapshot store operation.
Control areas that may be included in a snapshot are:
+ Channel Select Panel - stores the page and current
selected channels. When the snapshot is recalled, it
is displayed at the Channel Select window and
Channel Select panel if applicable.
+ Monitor 1 - stores the windows layout on monitor 1.
+ Monitor 2 - stores the windows layout on monitor 2.
+ Monitor 3 - stores the windows layout on monitor 3.
+ Encoders - stores the current encoder status.
+ Palettes - stores configuration including bank and
page selection, as well as, active states such as
QuickFocus and Manual Timing.
+ Center Display - stores configuration for the central command-line touchscreen.
+ System Configuration - stores system configuration settings.
+ Submaster Display and/or faders - stores the current state of any or all submasters. This includes active
submaster banks (1-10, 11-20, 21-30). The submaster control, settings, function filters, rates, operating modes,
the active and pending cues, etc. are all saved as part of the snapshot.
Pressing the [Snap Shot] button in the command line will bring up the Snapshot Filter window.
Snapshot Filter
Tip