Channels tab – PRG Vx76 User Manual 3.6 User Manual
Page 150
134
VX76 SOFTWARE USER MANUAL
Channels Tab
The Channels tab shows the current channels contained in the selected group. A "channel selector" at the top of the
window determines how - or if - channels get collected into the group. The channel selector options are as follows:
+
Stored - all selected channels will be collected into the group.
+
Rules - a set of one or more rules determines which channels are loaded into the group. Rules can be added
using the
New Rule
button or deleted using the
X
button. Rules can be additive
+
or subtractive
-
, "is" or
"is not," and can be applied to specific channels as determined by the Fixture Type selection. Additional
conditions can be added to a rule using the
&
button.
+
None - no channels are collected into the group. However, the group can still contain arrangement information to
modify a current channel selection. (This allows an "arrangement" to be pre-defined and then applied to a
selected group of channels at a later time. See
"Arrangement"
on the following page.)
Channel Select Options
Channels in Group
Tab
Channel Select Options
Rules
New Rule Button
Channel Select Options