PRG Vx76 User Manual 3.6 - Manual (Page 276)

260 VX76 SOFTWARE USER MANUAL
Selective Store
The Selective Store feature is used to modify or add parameter data to a cue, preset, or beam state for specified
channels (
active or inactive ). For example, with this function you could modify a cue’s color parameters, while leaving
all other parameter data intact for a particular cue or a range of cues.
Selective Store is most useful when you know the exact range of cues to be modified.
Note: Unlike Update, Selective Store commands are routed through the Channel Select panel and the filter settings.
Selective Store new data for a particular parameter in a cue:
Step 1. Select required channels.
Step 2. At touchscreen, modify a parameter(s) as required. For example, color.
Step 3. Press [Sel Store] <Cue> [n] [Enter]. The new color parameters will be stored in place of the old color
parameters, but all other parameter data will remain the same.
Selective Store new data for a particular parameter in a range of cues:
Step 1. Select required channels.
Step 2. At touchscreen, modify a parameter(s) as required. For example, color.
Step 3. Press [Sel Store] <Cue> [n] [Thru] [m] [Enter]. The new color parameters will be stored in place of the old
color parameters, but all other parameter data will remain the same.
Note: As a caution when altering parameters for more than ten cues, a confirmation window will open.
Selective Store all selected channels into a cue:
Step 1. Select required channels.
Step 2. Using manual control, set parameters as required.
Step 3. At touchscreen, set filters as required.
Step 4. Press [Sel Store] <Cue> [n] [Enter]. All selected channels are re-stored into the specified cue at current
stage levels. Only those parameters allowed by the filter settings are affected.
Modify a preset using Selective Store:
Step 1. At touchscreen display, modify filter settings as required.
Step 2. Select required channels.
Step 3. Press and hold [Sel Store] while pressing

Preset Palette Button

or [Sel Store] [Preset] [n] [Enter] (where n is
the discrete Preset number).
Undo (reverse) a Selective Store command:
+ [Undo] [Enter] - reverses the last store/update/delete command.
Tip